Outlet Valve Kit (PC+) Brand_Titan Formerly Part #0284041

Formerly Part #0284041

Also note: not all regulators are made the same

or available at this link: Owner's Manual

Unscrew the nut with a wrench and remove the retainer block

and replace the hydraulic fluid

Outlet Valve Kit (PC+) Brand_Titan Formerly Part #0284041Installation instructions are shown below. Replacement of the outlet valve may be necessary if your spray performance remains poor after having performed all the steps contained in the Spraying Troubleshooting section of the owner's manual. Replacing the Outlet Valve: Unscrew the outlet valve from the outlet valve housing using an adjustable wrench. Inspect the inside of the outlet valve housing (a). Clean any accumulated paint. Replace with a new